Powrtouch Heavy Duty Single
The Powrtouch Heavy Duty mover is designed to fit caravans that have shock absorbers fitted or have a narrow gap (less than 105mm (4.125ins)) between the chassis and the tyre, but fitted with a reduction gearbox to provide more moving power to the caravan wheels. Under ideal conditions it is expected that this model will move a 1500 kgs (approx 1.5UK tons) caravan up a 1 in 4 slope. This is the most powerful single axle caravan mover on the market. 5 year Guarantee!. Price is for a standard fit to steel chassis caravans, non standard and aluminium chassis may require a special fit
Price includes Powrbar Engage both sides of the Powrtouch unit at the same time!

Powrtouch Twin
The Standard Powrtouch Twin Axle caravan mover we supply that drives two wheels only! This model of Powrtouch is the only one recommended to be fitted behind the rear wheels; the reason for this is to obtain the best possible turning performance that is achieved by slightly lifting the jockey wheel it is expected that the caravan will turn quicker. Will fit the majority of twin axle caravans up to a recommended 1700 KGS (MTPLM). 5 year Guarantee!. Price is for a standard fit to steel chassis caravans, aluminium chassis may require a special fit.
Price includes Powrbar Engage both sides of the Powrtouch unit at the same time!

Powrtouch All Wheel Drive Twin
The Powrtouch All Wheel Drive Twin axle caravan mover (Developed from the Powrlaunch) drives all four wheels of the caravan; this model is required where the twin axle caravan is over 1700 kgs (MTPLM), may be used on a steep slope, turning uphill or on uneven ground (where the drive wheels may lift off the ground).Will fit the majority of all twin axle caravans. NOTE: The ALKO jacking points will have to be removed and an alternative method of jacking the caravan sought (for further advice see Caravan Club Handbook Technical Section). Price is for a standard fit to steel chassis caravans, non standard and aluminium chassis may require a special fit.

Powractuator
The drive rollers can be positioned on or off the tyres by a simple press of a switch. The Powractuator is a 12 volt linear actuator that replaces the over-lock CAM system for engaging and disengaging the rollers to the tyres. As some existing parts are removed the new Powractuator does not add any weight to the existing Powrtouch Mover. Should you have a battery failure when the rollers are located on the tyre they can be removed by turning a small shaft by hand (9 mm Hex) or with a battery operated tool (not supplied).